Hi,
my valve seems already fully build together (see attached picture).
valve.jpg
Do I have to remove the radiator cap before removing the old valve (I don't understand this point in the howto).
Ciao!
Hi,
my valve seems already fully build together (see attached picture).
valve.jpg
Do I have to remove the radiator cap before removing the old valve (I don't understand this point in the howto).
Ciao!
No, leave the radiator cap on, that way you will not drain the coolant.
This 'How To' may be better for you Marcus.
https://www.two-sixties.co.uk/mgoc26...e-heater-valve
Nich.
Nicholas John Peter Tinker - # 484
Manufactured on Tuesday 27th April 2004 @ 12.17.47.
Commission Number: 24468.
Brochure Model: M3 Tourer 4.6 V8 260PS.
Specification Code: L01B.
CICode: D1511.
Trim Level: TL8.9 (M3).
65th ZT-T 260SE to be made out of 115.
11th ZT-T 260 SE in Pearl Black (PBT) out of 23 produced.
Manufactured in the UK by MG Rover Group Ltd.
Ah, I understand. Thanks.
My valve came without these spacers which are shown in the howto
PICT2965.jpg
Is there something missing?
v.jpg
Ciao!
Last edited by schoppa; 10-07-2013 at 10:16 PM.
Fear keeps you alive. Fearless gets you killed
Herman
Vin#076 pics, Black, modified and with 234 RWHP and 276 lb/ft (275 BHP and 440 Nm @ flywheel)
FJ1200, DynoJet Stage 1, K&N filter
Alfa MiTo 1.4 Cloverleaf, 170 BHP, Alfa Rosso.
Looking at Post #15 in this link Marcus, it looks like the spacers aren't always needed. I haven't done this upgrade myself so I can't comment accurately but I am sure someone will be along to advise with more accurate information soon.
https://www.two-sixties.co.uk/mgoc26...e-heater-valve
Nich.
Nicholas John Peter Tinker - # 484
Manufactured on Tuesday 27th April 2004 @ 12.17.47.
Commission Number: 24468.
Brochure Model: M3 Tourer 4.6 V8 260PS.
Specification Code: L01B.
CICode: D1511.
Trim Level: TL8.9 (M3).
65th ZT-T 260SE to be made out of 115.
11th ZT-T 260 SE in Pearl Black (PBT) out of 23 produced.
Manufactured in the UK by MG Rover Group Ltd.
Didn't use the spacer on mine. Plenty of space for the pipework and bolting the backplate straight to the bulkhead makes for a more secure fit. Have a look at this:-
https://www.two-sixties.co.uk/mgoc26...r-upgraded-one
Dave Rushfirth
Empty garage where #138 used to be
Thanks Dave, I have added this to the How To section as well.
Nich.
Nicholas John Peter Tinker - # 484
Manufactured on Tuesday 27th April 2004 @ 12.17.47.
Commission Number: 24468.
Brochure Model: M3 Tourer 4.6 V8 260PS.
Specification Code: L01B.
CICode: D1511.
Trim Level: TL8.9 (M3).
65th ZT-T 260SE to be made out of 115.
11th ZT-T 260 SE in Pearl Black (PBT) out of 23 produced.
Manufactured in the UK by MG Rover Group Ltd.