Gear issue

[torque2me]

Hi all,

Have a real issue trying to get into and out of gear.

Possible causes are:-

1. Gearbox
1a. Bent selection fork
1b. Weak synchro

2. Clutch
2a. Warped clutch

3. Clutch hydraulics ( I take it they are fitted?)


Symptoms:-

(a) If engine is started in neutral then it is impossible to select ANY gear. Once engine/gearbox are warm (gearbox oil) then it is possible to select upwards if done slowly but it is very notchy. Impossible to change down unless at a virtual stop and, again, it improves when gearbox oil is warm but first gear remains virtually impossible unless many, many oaths have been issued over a great period of time.

I have to start in-gear. I press the clutch down - which should give a neutral state - but the car will move as the clutch (for whatever reason) is not freed. It is not possible to take it out of gear unless the engine is switched off.

(b) Clutch pedal travel is poor - my guess is it only starts to become effective over the last inch or so.


My feeling is hydraulics with warped clutch second as these symptoms started at only 20k miles. Is the vehicle fitted with a master and slave?

I read that Dreadnought had fitted a ZF box. Does anyone know the model/type? Did they fit clutch uprated facing material or left the original in?

Any ideas or thoughts gratefully received as I would prefer to replace the part causing the problem rather than renew all three.


regards,

Kev

[tom_2084]

Hi mate

Sounds to me like a clutch issue
Yes we do have hydralic master and slave cyclinders on our car for the clutch

I've had simular issues sounds to me like a leaking master cyclinder which is under the dash with the pedals. if you put your hand down around that area you may find bit of oil around there.

I could be wrong tho best get checked out by a garage

[torque2me]

Hi mate

Sounds to me like a clutch issue
Yes we do have hydralic master and slave cyclinders on our car for the clutch

I've had simular issues sounds to me like a leaking master cyclinder which is under the dash with the pedals. if you put your hand down around that area you may find bit of oil around there.

I could be wrong tho best get checked out by a garage

I'm leaning that way, very long, soft travel.

[torque2me]

Hi mate

Sounds to me like a clutch issue
Yes we do have hydralic master and slave cyclinders on our car for the clutch

I've had simular issues sounds to me like a leaking master cyclinder which is under the dash with the pedals. if you put your hand down around that area you may find bit of oil around there.

I could be wrong tho best get checked out by a garage

Tom,

A bleed did the trick. Now my cruise is not working but I don't know when it failed. Perhaps it has never worked from new - I have never had the need to use the unnnecessary accessory.


regards,


Kev

[AndyG]

Tom,

A bleed did the trick. Now my cruise is not working but I don't know when it failed. Perhaps it has never worked from new - I have never had the need to use the unnnecessary accessory.
regards,

Kev

Check the switches on the clutch and brake pedals.

[Coasting]

I have never had the need to use the unnnecessary accessory.


regards,


Kev

So why do you want to use it now?

[torque2me]

So why do you want to use it now?

Cause SE spec includes it and when selling on some people actually go for the whistles and bells and thus will be wanting me to fix it before parting with a lowly amount of readies :-)


cheers,

Kev

[Coasting]

OIC you are selling yours?

Whats the details on yours? Any pictures?

Sounds like you have got fed up with the ZT now...

[Fishy]

Hello Kev,

Does this improve if you pump the clutch pedal a few times - before trying to select the gear?

Regards,
Fishy

[colintf]

hope its sorted soon Kev.

Where in the world are you??????