Rear Brakes

[greeners]

If anyone has a shoe to hand, could they mention the lining size, length and width please.

I'll have a trawl through their catologue and see if I can find a similar size shoe.

[bernard lpg]

If anyone has a shoe to hand, could they mention the lining size, length and width please.

I'll have a trawl through their catologue and see if I can find a similar size shoe.

I'm on it but keep getting sidetracked.

[greeners]

I'm on it but keep getting sidetracked.

I wish I was getting sidetracked....I'm stuck at work....

[bernard lpg]

I wish I was getting sidetracked....I'm stuck at work....

I almost wish that I was at work, I keep getting sidetracked with cooking and housework.

It's a bit difficult knowing which measurements to take except for the width which is 30mm (29.9 for the ironmongery to be exact). So I've taken this pic on a grid background, unfortunately in imperial as it's what I used to use for PCB layouts.

If you want any detailed measurements perhaps you could indicate which and/or I could email a higher resolution piccie to you.

Correction, I cannot get this photo to load from photobucket, I've not had problems before, don't know what is going on, got to go, housekeeping duties again!

[greeners]

I assume they measure the lining flat as a rectangle.....

But I'll see what come out at 30mm width...

Thanks

[bernard lpg]

I assume they measure the lining flat as a rectangle.....

But I'll see what come out at 30mm width...

Thanks

The length measured along the circumference is 223mm of which 170mm is effective due to the chamfering.

Also a high-res photo in my gallery. I had quite forgotten this facility.

[onzlo]

The length measured along the circumference is 223mm of which 170mm is effective due to the chamfering.

Also a high-res photo in my gallery. I had quite forgotten this facility.

hi thank you all for your replies, i got impatient and went for £800 option ouch !!!!!!

Pete

[colintf]

doesn't les at SMC still have a set?