Rear subframe replacement
Results 1 to 10 of 19

Thread: Rear subframe replacement

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    No.146 Zt260 SE
    Join Date
    Jan 2012
    Location
    Eldroth, North Yorkshire
    Posts
    115

    Default

    Hi Andy and welcome aboard. I am in the process of arranging a replacement subframe for No.146 at the moment. As well as the other suggestions for advice, I suggest when you go green, speak to Dominic who deals with replacement subframes on behalf of the club. He is a mine of useful information for those, like myself, who may not be fully up to speed on the technical aspects and options to overcome the problem. He has kindly arranged to have the replacement refurbished subframe enamelled at his end and I am arranging to replace bushes/bolts and fit stronger link arms as well. So I will basically end up with better than new with the confidence that it should never be a problem again.

  2. #2
    happy maniac wraith01mg's Avatar
    Join Date
    Jul 2010
    Location
    Melton Mowbray Leicestershire
    Posts
    1,095

    Default

    How does one detach the propshaft from the diff. I'm in the middle of doing mine and it just won't come off.
    Chris Barrett..
    Sunny Melton Mowbray by the sea

    THE MAN WHO INVENTED THE WHEEL WAS AN IDIOT!

    Now, the man who invented the other three, he was a genius.

  3. #3
    Registered User
    Join Date
    Sep 2014
    Location
    East Yorkshire
    Posts
    273

    Default

    Loosening the bolts was one of the first things I did, I think while the wheels were still on, but I might be wrong. If the handbrake is still there then put it on, otherwise stick the engine in first gear. I don't recall it being too difficult at all.

    The bolts have a loctite coating which breaks down under heating. If needed, apply heat to the bolt heads. I had enormous difficulty in separating the drive shafts from the diff until I applied heat. Be careful though to keep the heat away from the oil seal.

    Andrew

  4. #4
    happy maniac wraith01mg's Avatar
    Join Date
    Jul 2010
    Location
    Melton Mowbray Leicestershire
    Posts
    1,095

    Default

    Cheers for the fast reply Andrew. I had no issues with the bolts so that was good. It was only when I got to lowering the subframe down that I realised that the shaft didn't come away from the diff. Turns out its just a pain and needs a firm clout to the side a few times and it'll just drop off. For future reference there is no internal spline for it to catch on, its just two facing plates behind the cv joint.
    Chris Barrett..
    Sunny Melton Mowbray by the sea

    THE MAN WHO INVENTED THE WHEEL WAS AN IDIOT!

    Now, the man who invented the other three, he was a genius.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •