Short engine, which would do the job, already offered on Post 6.Originally Posted by MrDoodles
Has no one got a aluminium block and a forged crank and rods to help him?
Short engine, which would do the job, already offered on Post 6.Has no one got a aluminium block and a forged crank and rods to help him?
Tony Dennis
I counted them in and I counted them out (with apologies to Brian Hanrahan) - 005, 007, 019, 051, 103, 288, 354, 455, 577, 700 - the story continues.
wow that must have been reving quite hard to have bent the rods like that
Has it not ceased up suddenly with the water ingestion?
I would think the sudden water ingestion caused it. At least I know the problem, will be a good project and a worthy car to get back on the road.
Got a complete 20k mile unit sat on a pallet I bought for a rainy day. PM sent.
regards,
Richard
Have a brand new set of pistons,rods and bearings sitting here could be bought for very little. Give me a PM if its of any interest if the block and crank are ok thats all you will need plus some gaskets. You may only require one piston and rod.
Last edited by scooter; 28-10-2012 at 12:02 PM.
Dominic,
One complete new(ish) 7,000 miles engine available. It was running perfectly when taken out.
Posting Permissions
Reply With Quote