All V8 Stuff.

[Blue Flash]

L and Right sun visors vgc non illuminated £15
1 number plate plinth (trophy blue) broken outer plastic stud(would repair though)£5
1 lower mesh mk1 bumper £10
2 spot light surrounds (trophy blue)£5
2 front bumper foams £10
1 steering wheel MG badge (vgc never fitted)£3
1 rear loom with parking sensors(no module) and holders (TB) ONE OF THE HOLDERS SCRATCHED /MARKED BUT WOULD PROBABLY SAND OUT £25
1 power steering pump (new)£50
chrome trim which includes 4 doors,4 small (rear of handle)2 front wing 1 rear wing(no threaded fastners on these but you could glue yours if you have them)£10
rear trincket holder £4
front bumper blanking plates x 2 £4

not put any postage up as I will have to get prices as and when if any member is interested.

Thanks Paul

[Merl]

Interested in the steering wheel badge as mine was scratched by a previous owner.... Never tried removing it though... can you post it Paul?

[Bainzi]

Ill have the Bumper foam please if they are for a Mk2 bumper, or if you think they could be made to fit?

[Blue Flash]

Interested in the steering wheel badge as mine was scratched by a previous owner.... Never tried removing it though... can you post it Paul?

Thats OK.....Hows ten bob sound for p&p....pm your details and will get it off soonest.

[Blue Flash]

Ill have the Bumper foam please if they are for a Mk2 bumper, or if you think they could be made to fit?

Hi Nigel... from a mk1...not sure if they are mk2 compatable though

[Merl]

Been reading up on how to replace the steering wheel badge and every post I find say it isn't possible and it is part of the airbag.... Paul have you or anyone else got any further insight on this?

[LINDEN CAHILL]

Hi Nigel... from a mk1...not sure if they are mk2 compatable though

different part numbers for mk1 and mk2 cars

[ColinE]

I'll take the power steering pump for club stock

Any way we can organise a relay down country for Brooklands to save the club postage costs

PM me payment details and I'll sort it out

Cheers

[Bainzi]

Ill pass on the foam then mate thank you.

But if your going to Harrogate this year ill take that fuse cover plate if its still up for grabs??

[Blue Flash]

Ill pass on the foam then mate thank you.

But if your going to Harrogate this year ill take that fuse cover plate if its still up for grabs??

No problem,re the cover thats gone AWOL!,how I did the cover was to remove the lid and fashion a sort of brass rubbing effect then after I got the template whizzed it down to a sheet metal shop,in hindsight wish I'd gone for 'ally as the stainless does not fettle up to the required "bling" rating........... presently at about 4.5 out of 10 after half a bottle of Brasso and hand draulic power!