Looking for a sticking-plaster for the eternal battery drain

To circumvent an unidentified battery drain on my v6 Contemporary I bought an isolator. This has proved to be most effective in preventing flat-battery-dom. However the v6 has the battery in an easily accessible engine-bay location. Having already enjoyed an anticipated dead battery in my very newly acquired v8 I wonder if there is a way of incorporating an isolator. Attached to the battery would not pose an insurmountable problem, merely inconvenient and physically taxing. Could an isolating switch be put on the power supply line somewhere more readily available? What is the red wire running to the engine-bay fuse box? Is that the primary distribution point or does the wiring separate into different circuits elsewhere. If the v8 electrical drain is from one of the circuits running out of the passenger footwell fuse box is there a single supply wire that could be isolated? No prizes for noticing I am no automobile electrician.

Unplugging the boot mounted CD-drive and TV tuner MAY be the only sticking plaster you need for now, then you can maybe home in on the drain?

David

Hi David, I was thinking more generically. A persistent battery drain seems to be an oft commented feature of the v8.

My newly acquired beastie has been treated to a new battery today. However I fully expect a problem tomorrow morning. As mentioned in an earlier post the light switch module is permanently illuminated. Hopefully I'll get a replacement tomorrow in case it's the switch and not the supply to same.

I have seen one of these used on a Jensen http://www.batterybrain.co.uk/produc...te-anti-theft/

Seemed a well made piece of kit and all you need to do is blip to switch it on and off.

Steve

It would be worth checking some of the known solutions first before embarking on the more drastic route of an isolator which as you rightly say is a 'sticking plaster' and will not solve the problems but just shelve them.
The problems caused by 'old' batteries are very strange, low battery voltage can cause problems with the wipers, the windows and the lights. Replacing the battery will at least give you a good starting point to work from.
Resetting the system by disconnecting the battery for at least 30 minutes should return everything to a normalised state and occasionally a few runs will reset the BCU if that throws up oddities.
The electrics under the floor of the boot can be affected by water ingress and may lead to systems not shutting down but this is an easy check, unlock the car with the key fob, open the boot to get sight of the satnav drive and wait for the light on the front of the unit to extinguish. This may take up to 10 minutes, whilst waiting listen for any sign of other electrical operation such as the fan on the TV tuner. Everything should stop...eventually. If it doesn't you have detected the source of your battery drain....if you have one. You can also check the voltage across the battery terminals with an ammeter but this requires a little bit more electrical knowledge.
It really is worth trying to identify the problem (that's if it isn't battery related).
You may well end up with an isolator but at least you will know what the problem is before going down that route.
If you are buying a battery make sure it's up to the job, information in the INDEX.
Nich.

If you are replacing the light switch module you may well have problems. As far as I know it carries information such as mileage covered and may well need coding to the car with a T4.

Nich.

Quote:

---

Originally Posted by oldie

Hopefully I'll get a replacement tomorrow in case it's the switch and not the supply to same.

---

Hi there, and welcome along!

Just a quick point about the LSM, if you change it, you'll get an error on the mileage display, some info HERE, there's plenty of help around to get one "virginised" :jaw

It's a good idea to get things sorted with a faulty LSM, they have been known to end up like this: :eek: https://www.flickr.com/photos/10615841@N07/10157740506/

Good luck!!

EDIT: Beaten to it! :-)

Thank you for the replies. By "light switch module" I mean the headlight switch to the right-hand side of the driver. namely this: https://www.two-sixties.co.uk/mgoc26...tid=8977&stc=1
Would that need a t4? It's the immediate and obvious source of a drain as it is constantly illuminated.

The car doesn't have the high-line sat-nav installation.

The replacement battery is a Yuasa Silver HSB096 80Ah/760amps.

Hi

Yes you will need a LSM matched to your mileage, I had the err on the dash caused by the previous owner swapping the LSM. I managed to get one matched from the 75and zt forum on a recon exchange basis.

I believe the LSM holds data including mileage and the vin number for the car, if the data doesn't match it shows the err on the trip mileage on the dash.


Simon

Just a query, can't the information from the old light module be transfered to the "New" module via T4 or "TOAF" software, did read on the 75 sight of one of the modules in the LSM being changed and it cured the problem, exactly same fault as Oldie's.

Here's a simple battery isolator from a company I deal with through my work

http://v2.gb.sparex.com/ItemDetails/...ttery+isolator

Quote:

---

Originally Posted by Les4048

Here's a simple battery isolator from a company I deal with through my work

http://v2.gb.sparex.com/ItemDetails/...ttery+isolator

---

That's similar to the type I use on my v6 when not driving for a while. They are very effective. However it is best if there is easy access to the battery. Apropos the light switch and a need for a t4: would using a replacement temporarily, prior to getting t4ed, pose a problem,; e.g. making the car undriveable or damaging other memory components? If I test the battery for current draw using a multimeter what sort of figures should I find?

Incidently, Seasonal Greetings to every body and thank you for the swift, knowledgeable suggestions/solutions/advice etc.

Quote:

---

Originally Posted by oldie

............ If I test the battery for current draw using a multimeter what sort of figures should I find?
...........................

---

You should get approx 12 volts + with everything off and then starting should not drop below 10 volts and then something in excess of 14 volts with the engine running, i.e. alternator charging the battery.
Nich.

If, for instance, the light switch is the offending article. What figures should I see when the switch is connected/disconnected. Would I be looking at the ammeter reading and where would I place the meters' probes? (Printable answers only please).

Quote:

---

Originally Posted by oldie

If, for instance, the light switch is the offending article. What figures should I see when the switch is connected/disconnected. Would I be looking at the ammeter reading and where would I place the meters' probes? (Printable answers only please).

---

Take a look at this thread https://www.two-sixties.co.uk/mgoc26...ighlight=drain
where you should find that info.

David

Sorry to be negative about our cars but I fear these mysterious electrical problems will become more common as they age. Car electronics are not designed to last for ever and with the inevitable damp these can cause problems.

I know of several modern cars that have been scrapped due to endless electrical problems and the cost of fixing was going to cost more than there worth, one very nice 7 series BMW even failed its MOT because of such problems now engine management lights, ABS and airbag lights are a failure. I am sure the manufacturers build in this need for T4 and the like on purpose, there is no need for a light switch to store the mileage information.


Steve

Quote:

---

Originally Posted by SCP440

Sorry to be negative about our cars but I fear these mysterious electrical problems will become more common as they age. Car electronics are not designed to last for ever and with the inevitable damp these can cause problems.

I know of several modern cars that have been scrapped due to endless electrical problems and the cost of fixing was going to cost more than there worth, one very nice 7 series BMW even failed its MOT because of such problems now engine management lights, ABS and airbag lights are a failure. I am sure the manufacturers build in this need for T4 and the like on purpose, there is no need for a light switch to store the mileage information.


Steve

---

I think that relates to any modernish car but I don't think it will be a failure and our cars though have electronics aren't on a par with todays cars. I think our history means there will be an owner who has the auto-electrical savi to find a solution to the problems which arise. Also if we as a collective start seeing issues arise we will find a solution.

I'm currently working on the electrical displays of a 35 year old bike and happily surprised to see no major degradation on the insulation etc so not overly concerned about our cars for a good few years yet. :)

Quote:

---

Originally Posted by SCP440

Sorry to be negative about our cars but I fear these mysterious electrical problems will become more common as they age. Car electronics are not designed to last for ever and with the inevitable damp these can cause problems.

I know of several modern cars that have been scrapped due to endless electrical problems and the cost of fixing was going to cost more than there worth, one very nice 7 series BMW even failed its MOT because of such problems now engine management lights, ABS and airbag lights are a failure. I am sure the manufacturers build in this need for T4 and the like on purpose, there is no need for a light switch to store the mileage information.


Steve

---

I guess electronics don't necessarily fail just because of age. More modern cars suffer from it too. The biggest problem will be when a "260-bespoke" piece of electronics fails and no replacement is available any more. There are many electronic modules and quite a few already fall into the NLA category, I understand.

David

Engine management is relatively easy as there are aftermarket engine ECU's a plenty. The problem will be as David has said the specialty components. I suppose the Gateway and heater control ECU's are the two most obvious as the rest could be robbed from a standard ZT/Rover 75. I believe the ABS is even unique to our cars. I know there are companies that specialise in the repair of such parts but it would probably be a good idea to remove these parts from any cars that get scrapped and they are kept safe for the future.