If you put a smear of dielectric grease inside the boot of the coil pack it will go on easier. Some manufacturers specify this in their manuals.
Steve
Printable View
If you put a smear of dielectric grease inside the boot of the coil pack it will go on easier. Some manufacturers specify this in their manuals.
Steve
The Ford V8 convention, Malcolm, is that that one (over by the EGR system) is number 8, not 4. When looking at the engine from the front of the car, the cylinders on your left are, front to back, 1,2,3,4 (Bank-1), and on your right, front to back, 5,6,7,8 (Bank-2). There is no universal numbering system, though. GM swap the banks over I believe. That is important to know, because the car's diagnostic system will refer to cylinders in the way specified by the manufacturer.
From Ford:"Ford Motor Company numbers its cylinders along each side from front to back. When looking at the engine, start on your actual left-hand side with the cylinder closest to you as number one, followed by two, three and four. Then look to your actual right-hand side; the cylinder closest to you is number five, moving along the line away from you to number eight."
Been trying to avoid suggesting this, but the fact that the misfire is indicated on Rick's car at #5, points to the possibility of a problem with the intake install. #5 is the plug next to the thermostat and top hose connection. IF the plug hole is wet, then it could be a coolant a leak. If it's not wet, ignore the rest of this post!
Easiest to fix would be a top rad-hose to thermostat join leakage (common; new silicone top radiator hose from club shop).
Coolant seepage could also be from the thermostat-housing to intake alloy crossover joint (O-ring, silicone grease).
(The other common problem of a leak between the alloy crossover piece and the plastic intake there, is caused by "plastic rot", so highly unlikely with a new Ford intake).
Most likely, unfortunately is that the intake was not properly fitted. Wrong torque, wrong sequence, or not torqued cold and then again finally when warm. Another very common problem when fitting a new intake, is that, although the gaskets should be fitted dry, the head alloy becomes corroded at the joints with the water galleries. A good gasket sealant should be used sparingly, on the head-side and only around those 4 points, to avoid leakage. I had that happen and I know of one more from another member a few months back. My leak was from the gasket near plug #8, so a rear gallery, caused I suspect by no sealant being used on a corroded surface and, also not re-torquing hot. Not done by me, but by my (ex-)garage.
David