WANTED:- gearbox seals and boots

as above really...

I have sourced the gearbox adapter plate from Scooter (just arrived thanks Brian)

I now require the gearbox to adapter plate gasket(this will be a standard shifter to tremec 3650 gasket

I also need what I believe is referred to as an 'inner boot' it is a dust boot covering the actual ball section of the shifter allowing the 14mm shaft out through the top (mine has perished(I believe it is vibration perished as the rubber has powdered) it sits in a recess of 49.6mm

less important, but I also need the two rubber boots that are at the bottom of the shifter/car body interface...

these last two boots are servicable...just, but the dust boot and gasket are required.

I have found the shifter gasket in the states @ $8 but would prefere a uk delivery for speed

any and all help gratefully received.

Thanks, Nick

Nocturnal, you have a PM.

SJR

TVR's used T-5 and then TR-3550 Tremmec boxes, so there is a good chance that they also used the TR-3650. there are quite a few TVR specialists about that might keep spares.

SJR

Thanks for the pm's Unfortunately I'm at work till 2200 :(

But I'll give 'em a bell tomorrow, THANKS!

Scooter has said just make a gasket for the adapter/gearbox joint so that I'll do, but the small dust cap boot I may ahve to find one from another application :( sa the gearbox adapter plate is a part made specifically for the job and the manufactureres told me they cant help.

I'm hoping Fishy can shed some light on that one
(dust boot 49.6mm recess x 14mm shaft,)
and the two larger boots, I'm not too worried about, as I can do those at a later date if neccessary as they are small tears, where as the dust boot is perished.

Nick