Steering Racks No Longer Available

[ablittle]

Can anyone help me out as to were I can either get one or recondition mine please

[Herman]

Lokk here http://www.mgroverpartfinder.com/XPART-MG-ROVER-PART-2052-QAB000420---Damen+++Kroes+Boxtel+B+V+.aspx?back=%2fShowProduct s.aspx%3fPageIndex%3d%26part%3dQAB000420%26browse% 3d&back1=%2fShowDealerProduct.aspx%3fPageIndex%3d%26p art%3dQAB000420%26browse%3d%26SortBy%3d%26directio n%3d&Amount=3&Price=empty

[colintf]

Whereabouts are you? :cool:

[ablittle]

I'm in North East Scotland

[colintf]

I'm in North East Scotland

try Brian (Scooter on here) at Dreadnought :cool:

[ksilver]

What's the problem with it?

[ksilver]

What's the problem with it?

Just seen your comments on other thread.

As said before try Brian at Dreadnought, he may be able to fix it.

[ablittle]

Thanks for replies

I did try Brian & he only had a new 1 hes keeping. Mine is broken off at the threads :{

I have ordered a rencnditioned rack so hope all goes well from there.........

[ksilver]

I have ordered a rencnditioned rack so hope all goes well from there.........

I hope you get the right one, our rack is essentially a LHD (non-V8) ZT rack turned upside down, if they just send a RHD (non-V8) ZT rack it won't fit.

[ksilver]

I'm in North East Scotland

I'm in Stonehaven, PM me if I can be of any help.

Ken

[Keith]

I have just gone down the route of replacing mine
as said above a LHD FWD ZT rack will fit but the inner tie rods will be too short as I found out by buying one :(

So if that is all you need they can be unscrewed as you only need to break the spot weld with stilsons then I suggest going to a Delphi stockist and try to match them up with a standard part.
Delphi supply a direct replacement for the standard FWD cars so I suspect they may well have one that about 30mm longer for our needs